Your water heater is a fixture in your home that you rarely think about until something goes wrong with it. With a simple phone call to your local plumber Caulfield, you should be able to get the repairs you require and have your heating functions restored within hours.
Could you imagine how miserable you’d be if you didn’t have that nice hot shower in the morning?
Although annual maintenance can help extend the life of your water heater, it does occasionally require professional repair. However, due to usage strain and tank age, your water heater will eventually need to be replaced.
If your water heater is getting on in years, it’s best to be on the lookout for warning signs that it needs to be replaced before it completely fails, leaving you without hot water.
Rust and Corrosion Around the Water Heater
It’s always a good idea to check for signs of rust and corrosion around the water heater. Keep an eye on your water heater tank and inspect it on a regular basis for any rust or corrosion that has accumulated over time.
You should pay special attention to two areas: the temperature and pressure relief valves, and the inlet and outlet connections. These areas are especially vulnerable to rust and corrosion buildup.
If you’re not sure where these areas are, ask your Plumber Caulfield at your next regular maintenance appointment, and they should be able to show you. Keeping these areas clean and maintained can help your unit last longer and delay the replacement of your hot water heater.
Pooling Around the Water Heater
When examining your unit for corrosion and corrosion, walk around the unit and look for any pools of water. If you notice any moisture, there is most likely a leak or crack inside your hot water tank.
As the metal in your tank heats up, it expands and cracks, allowing water to escape through the lesions. This could be causing the tank to leak, and it could also indicate that it’s time to replace the water heater.
Strange Noises
Another common cause of water heater failure is water heater noise. It’s time to call experts if your water heater is making popping, creaking, or rumbling noises. Water heater noises can also be caused by hard water and mineral buildup.
Minerals forming a layer on the surface of the water heater cause the distinct popping noise. Pockets of air in the sediment layer are boiling along with the water in your tank, causing the sound.
Water Heater Not Heating
If your water heater isn’t heating up, it might be time for a replacement. Check the following signs to determine if it’s time for a water heater replacement:
-The water in the hot water tank is cool to the touch.
-The water heater flue is open.
-The power to the water heater is off and the thermostat is set to the “off” position.
-There is a water leak from the water heater.
Naturally, a water heater with one foot in the grave will stop working. If your hot water is no longer hot or is only hot occasionally, it may be time to replace the heater.
Sometimes the internal devices and mechanisms wear out or break, causing your heater to stop heating. In some cases, a simple repair may be required. However, a complete replacement may be required.
